4F Terminal box for fiber optic cable-Aixton brand

(1) The fiber optic panel provides the following four fiber end installation methods:
a) Install an L-type field-ended socket.
b) Install straight field terminated sockets.
c) Install on-site terminal plugs and optical adapters.
d) Install fiber optic hot melt and optical adapter.
The optical fiber panel can be compatible with any of the above methods. The L-shaped field-terminated socket is not a necessary condition. If the field-terminated plug and adapter are installed in the socket, the adapter interface cannot protrude from the socket panel.
The fiber optic movable connector plugs and adapters in the fiber optic panel should use SC and LC types, and they should comply with the communications industry standards for relevant products.
(2) Other functions of fiber optic panel:
a) The fiber optic panel can be easily opened and used, and should have a certain dust-proof function.
b) The optical fiber panel can provide various connection methods such as fusion splicing, cold splicing, and on-site connection, and provide fixation and protection for the optical fiber splice head.
c) It can provide single-core or two-core optical cable access and port output, and the interface type is SC or LC type adapter.
d) The optical fiber panel has the function of fixing butterfly-shaped cable introduction and other conventional indoor and outdoor optical cables without affecting its performance.
e) The optical fiber panel should have sufficient cable coiling space. The bending radius of the optical fiber or optical cable inside the panel should be no less than 30mm, leaving no less than 40cm of home optical cable.
f) Fully meet the requirements of the optical fiber bending radius, and provide wiring routing and protection for the introduced optical fiber.
g) Butterfly introduction optical cable can be introduced from the side or bottom of the fiber optic panel.