How to install a 24-port patch panel-Aixton

Prepare the network cable, peel off 2 cm of the outer skin at both ends, remove the aluminum foil, and smooth the ground wire.
Cut off the cross frame in the middle of the network cable.
Sort the network cables according to the color of the line position sticker.
Remove the rear bracket of the patch panel to ensure smooth subsequent operations.
According to the 568A or 568B line sequence, press the corresponding color network cable into the wire trough by hand.
Use the wire crimping end of the wire crimping knife to press the network cables into the terminal block one by one.
After tightening the network cable, cut off the excess part to complete the crimping.
Install the rear bracket, take out the cable tie and tie it to the T-shaped part to fix the network cable.
Tighten the cable tie and cut off the excess part.
Repeat the above steps until all network cables are crimped.