Single-jacket ADSS consists of loose tubes, aramid yarns and one layer of HDPE outer sheath. Double-jacket ADSS adds an outer anti-tracking (AT) sheath over the inner HDPE layer. The key advantage of the outer AT layer is resisting leakage tracking and corrosion under strong electric fields. Selection mainly depends on voltage class and electric field zone of the installation spot. For high-voltage lines at 110kV, 220kV or above where the cable sits in a strong electric field area, double-jacket anti-tracking ADSS is compulsory. For lines of 35kV and below with low electric field strength far from phase conductors, single-jacket ADSS is acceptable and more cost-effective. A common mistake: even for low-voltage lines, if the hanging point is very close to live conductors, local electric field can still damage the jacket over time. In such cases, double-jacket type is still suggested. Anti-tracking sheath uses special compound formula and must pass professional tracking tests. A thickened ordinary HDPE layer cannot replace genuine AT sheath. Double-jacket ADSS has larger diameter and higher weight, so suspension and tension hardware cannot be reused from single-jacket orders. Buyers must clearly mark “anti-tracking AT sheath” in contracts and request tracking test reports to prevent counterfeit products.
All Products
-
Outdoor Fiber Optic Cable
-
Indoor Fiber Optic Cable
-
ADSS Fiber Optic Cable
-
FTTH Drop Cable
-
Fiber Optic Patch Cord
-
Fiber Optic Accessories
-
CAT5E Ethernet Cable
-
CAT6 Ethernet Cable
-
CAT6A CAT7 CAT8 Cable
-
Network Patch Cord
-
CAT3 Telephone Cable
-
RG59 RG6 Coaxial Cable
-
KeyStone Jack FacePlate
-
RJ45 Connector
-
Network Patch Panel
-
G657A2 Fiber
What is the difference between single-jacket and double-jacket ADSS? How to select?
November 14, 2026

