Step 1: Put the Category 6 network cable into the prepared stripping knife, rotate the stripper, peel off the 2-3cm outer quilt, and cut off the cross frame inside the Category 6 network cable.
Step 2: Cut the cross frame, separate the wire cores, and insert the wire cores into the card slots corresponding to the wire sequence according to the wire sequence identification on the module (usually we use the wire sequence of T568B).
Step 3: After inserting the wire core into the card slot, use the prepared wire cutter, press firmly to make the wire core copper wire fully contact with the card cutter, and then cover the back cover. In this way, the six types of modules are connected.
All Products
-
Outdoor Fiber Optic Cable
-
Indoor Fiber Optic Cable
-
ADSS Fiber Optic Cable
-
FTTH Drop Cable
-
Fiber Optic Patch Cord
-
Fiber Optic Accessories
-
CAT5E Ethernet Cable
-
CAT6 Ethernet Cable
-
CAT6A CAT7 CAT8 Cable
-
Network Patch Cord
-
CAT3 Telephone Cable
-
RG59 RG6 Coaxial Cable
-
KeyStone Jack FacePlate
-
RJ45 Connector
-
Network Patch Panel
Aixton-Module wiring method
November 5, 2022
