Category 7 module wiring requires specialized tools and adherence to shielding wire handling specifications. The following are the detailed steps:
Tools and Materials Preparation
You will need Category 7 shielded network cable, Category 7 shielded module (punch-down type recommended), wire stripper, punch-down tool (or network cable crimping tool), scissors, cable ties, and a network tester.
Wiring Steps
Wire Stripping: Use a wire stripper to rotate and remove the outer sheath, exposing approximately 2-3 cm of the wire cores. Be careful not to damage the internal wire pairs. Then, cut off the internal cross-shaped frame of the network cable (if present).
Shielding Layer Treatment: Twist the internal aluminum-magnesium braided wire and ground wire together. Cut off the aluminum foil shielding layer that wraps the wire pairs.
Wire Insertion and Arrangement: Thread the wire cores through the module's back cover and insert them into the corresponding slots according to